Servo Winch

This is a basic servo that has been modified for winch operation. 

A 3D printed spool has been attached to the servo shaft to act as the winch drum.

The stock servo amplifier circuit board has been removed and replaced with one of my No Drift Winch Controllers so you can use this winch with confidence - you won't be constantly fighting with trim controls to stop the winch from spooling in or out when it should just be sitting still.

As an option, you can specify a different winch controller circuit.  Choose the 2 Position Channel if the channel on your radio system that you want to operate the winch with only works in two positions.  
Note that the choice of the HV controller is no longer available.

The winch is not supplied with a winch line. 

NEW: Added the choice of using a 3PWR4 relay output winch controller.  This will let you use battery power to operate the winch instead of receiver power.  Keep in mind that 12 volts (3S Lipo) should be the highest you go or you will have very short winch life.  The winch controller can be ordered with double deans style or double XT60 power connection.
This version of winch controller expects no more than six volts on the receiver connector.  If you run more than six volts to the receive, please contact me at mostlyal @ gmail.com to order the H version of the controller (adds $5 to the price).